8555-M210-O1 Rev R 758C Owner’s 26
SETUP AND CALIBRATION, CONT.
Htr= (DIGITAL HEIGHT ROD)
This setting determines whether the height rod port is enabled for the Detecto DHR (Digital
Height Rod). With the port enable and the height rod connected, the BMI will automatically
be calculated and displayed when the height rod is raised and placed on the patient’s head.
With display showing Htr=, press PRINT/ENTER key to show current setting. If setting
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise use numeric keys
0/NO or 1/YES and enter a new setting. Press PRINT/ENTER key to save it.
0 = Height Rod Port is Disabled 1 = Height Rod Port is Enabled
bni= (BMI CALCULATION FEATURE)
This setting determines whether the indicator operates as a basic (weigh calculation only)
indicator or performs the Body Mass Index (BMI) calculation.
With display showing
m
bni=, press PRINT/ENTER key to show current setting. If setting
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise use numeric keys
0/NO or 1/YES and enter a new setting. Press PRINT/ENTER key to save it.
0 = BMI Disabled 1 = BMI Enabled
P220= (P220 PRINTER)
This setting determines whether weight data sent to the serial port is formatted for a P220
printer or a P185 printer (see CRLF= prompt to select P185 printing mode).
With display showing P220=, press PRINT/ENTER key to show current setting. If setting
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise, using numeric keys
0/NO or 1/YES, enter a new setting, then press PRINT/ENTER key to save it.
0 = NO (Weight Data is Formatted for
P185 printer)
1 = YES (Weight Data is Formatted for
P220 printer)
IMPORTANT! If you select P220=1 (Weight Data is Formatted for P220 printer), the
display will skip to the baUd= prompt.
CrLF= (P185 PRINTER MODE)
This setting determines whether weight data sent to the serial port is formatted for a P185
printer in Journal mode or a P185 printer in Ticket mode. NOTE: If you select CRLF= 1,
(Ticket Mode), an additional prompt (EOP=) will be displayed.
With display showing CRLF=, press the PRINT/ENTER key to show current setting. If setting
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise use numeric keys
0/NO or 1/YES and enter a new setting. Press PRINT/ENTER key to save it.
0 = Set Serial Format for P185 Printer
in Journal Mode
1 = Set Serial Format for P185 Printer
in Ticket Mode
IMPORTANT! The EOP= END OF PRINT LINEFEEDS prompt will only be displayed if
you select P220=0 and CRLF=1.
To Next Page
Loading...
Need help?
General
