4. Components
5. Before Using
Make sure that the headset is fully charged for at least four hours
before initial use. Subsequent charging should take two to three hours.
1. Connect the wall charger to Charging Jack of the headset (located
between the two Volume Control buttons).
2. While charging, the red status light illuminates. When charging is
complete the light will turn off.
11
Headset
Speaker
Microphone
Press on Tab to
release headset
Sliding Plate
Clamp
Sliding Panel
Volume Up
Volume Down
Charging Jack
Status Light
Control Button
Button serves as:
• Reject / Redial / End Button
• Radio Button
To Next Page
Loading...
Need help?
General
