Cannot terminate calls using Your phone supports the Bluetooth headset profile
the Reject/Redial/End functions only and not the handsfree profile. Therefore you
must use the Control button to answer or terminate
calls.
Can’t answer phone calls 1. Make sure that the VC feature is activated
using the Voice Command 2. Make sure that you speak the word loudly after
(VC) feature. prompting
I cannot perform redial 1. Make sure that the call list on your phone is not
empty.
2. The Redial feature works only with mobile
phones that support the handsfree profile. Make
sure that your phone supports this profile.
Battery does not provide at Make sure your scala-rider FM headset is fully
least five hours of talk time charged. Charging time is up to 3 hours for an
empty battery. When the headset is connected to
the charger and it is fully charged, the red Indicator
Light turns off.
I’m trying to reject incoming 1. Make sure the VC feature is enabled (see
calls by remaining silent, Section 7).
but the phone continues to 2. Reject feature works only with mobile phones
ring. that support the hands-free profile. Make
sure your mobile phone supports this profile.
Red Status Light does not 1. Make sure the charger’s DC jack is firmly
light steady when charger is plugged into the headset.
connected. 2. Disconnect the charger’s DC jack, wait a few
seconds and plug it back in.
31
To Next Page
Loading...
Need help?
General
