Carlin 102CRD 99FRD - PLEASE Read this First; Codes and Standards

Model 99FRD, 100CRD & 102CRD oil burners — Instruction manual
Carlin part number MN99102 Rev. 08/20/08
– 2 –
PLEASE read this first . . .
Special attention flags
Please pay particular attention to the following when you see them through-
out this manual.
Notifies you of hazards that WILL cause severe personal injury,
death or substantial property damage.
Notifies you of hazards that CAN cause severe personal injury,
death or substantial property damage.
Notifies you of hazards that WILL or CAN cause minor personal
injury or property damage.
Notifies you of special instructions on installation, operation or
maintenance that are important, but are not normally related
to injury or property damage hazards.
General information
Burner applications
Follow all instructions in this manual, the primary control data sheet and
the appliance manual. Verify the burner is correct for the appliance being
used and for all applicable codes/standards.
Damage or shortage claims
The consignee of the shipment must file damage or shortage claims im-
mediately against the transportation company.
When calling or writing about the burner . . .
Please provide us with the UL serial number and burner model number
to assist us in locating information. This information can be helpful when
troubleshooting or obtaining replacement parts.
Follow the guidelines below to avoid potential severe
personal injury, death or substantial property damage.
Installer/service technician . . .
• Readallinstructionsbeforeproceeding.Performallprocedures,
and in the order given to avoid potential of severe personal injury,
death or substantial property damage.
• Beforeleavingthesiteafterstartuporservice,reviewtheUser’s
information page with the user. Make the user aware of all potential
hazards and perform the training outlined below.
Train the user . . .
• Toproperlyoperatetheburner/applianceperthismanualandthe
appliance instructions see User’s information.
• Tokeepthismanualatorneartheburner/applianceforreadyac-
cess by the user and service technician.
• To contact the service technician or oil dealer ifheencounters
problems with the burner/appliance.
• Tokeeptheappliancespacefreeofammableliquidsorvapors
and other combustible materials.
• Donotuselaundryproducts,paints,varnishesorotherchemicals
in the room occupied by the burner/appliance.
• Tocontacttheservicetechnicianatleastannuallyforstartupand
burner/appliance service.
When servicing the burner . . .
• Disconnectelectricalsupplytoburnerbeforeattemptingtoservice
to avoid electrical shock or possible injury from moving parts.
• Burner and appliance components canbeextremely hot.Allow
all parts to cool before attempting to handle or service to avoid
potential of severe burns.
Should overheating occur:
(1) shut off the oil supply to the burner.
(2) do not shut off the control switch to the circulator or
Certification
99FRD, 100CRD,and102CRDburnersare U.L.listed for the U.S. and
Canada,certiedtocomplywithANSI/UL296,forusewith#1or#2heating
oil(perstandardASTMD396).
Burnerlabelslistcompliance,whenrequired,withspeciallocal,stateor
provincial approvals.
in this manual.
United States installations
Burner/applianceinstallationsintheUnitedStatesmustcomplywiththe
latest editions of NFPA31 (Standardfor the Installation of Oil-Burning
Equipment),ANSI/NFPA70(NationalElectricalCode),andallapplicable
local codes.
Canadian installations
Burner/applianceinstallationsinCanadamustcomplywiththelatesteditions
ofCSAB139(InstallationCodeforOilBurningEquipment),CSAstandard
Codes and standards
Install this burner in accordance with all local codes and
authorities having jurisdiction. Regulations of these authori-
ties take precedence over the general instructions provided