Carlin 102CRD 99FRD - User Care and Maintenance

Model 99FRD, 100CRD & 102CRD oil burners — Instruction manual
Carlin part number MN99102 Rev. 08/20/08
– 28 –
For other than routine maintenance, contact
a qualified service company. Perform the
following as needed.
• Keepthe area around the burner clear
and free from combustible vapors and
liquids.
• Do not obstruct the ow of combustion
and ventilating air.
• Mostmotorscurrentlyusedonresidential
type burners use permanently-lubricated
bearings, and do not require field lubri-
cation. Read the label on the motor to
determine oiling needs, if any. Do not
over-lubricate. This can cause as much
trouble as not lubricating at all.
Never attempt to use gasoline as
a fuel for this burner, as it is more
combustible and could result in a
serious explosion. Never attempt to
burn refuse or use any fuel other
than#1or#2heatingoil(ASTM
99FRD, 100CRD, and
102CRD oil burner
User care and maintenance
Refer only to the information on this
page, intended for your use. The
remainder of this manual is intended
only for your service technician.
Failure to comply could result in
severe personal injury, death or
substantial property damage.
Should overheating occur:
(1) shut off the oil supply to the burner.
(2) DONOT shut off the control switch to the
circulator or blower.
 (3)contactyouroildealerorservicetechni-
cian and the fire department (if needed).
The burner must be cleaned, tested
and adjusted annually by a qualified oil
burner service technician.