EasyManuals Logo

Carrier TRANSICOLD Vector 8600MT User Manual

Carrier TRANSICOLD Vector 8600MT
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
9 62-11648
1. Place the START/RUN-OFF switch in the START/RUN position.
NOTE
The unit will automatically start in the same operating state (Engine
Operation or Electric Operation) it was in when last stopped.
NOTE
If required, the system will initiate a “Soft Start” / “Bump Start”
procedure to clear any liquid refrigerant or oil. During this procedure,
the compressor will be started for one second and then shut down for
nine seconds, up to five times.
2. The system will display the Carrier Transicold logo, display the default
screen, present language selection and the hour meter readings (if
configured to do so) along with a test flash of the alarm light. Next, the
system will perform a start sequence, energize the buzzer, and then start
the unit automatically.
NOTE
If the unit attempts to start in Electric Operation, and power is not
available, the A00073 - “NO POWER - CHECK POWER CORD”
alarm may be activated. This alarm will clear if power is restored. If
this alarm condition exists for five minutes and the Functions and
Configurations are set to allow a switch, the unit will switch to Engine
Operation. This unit may have the option installed to switch from
electric to diesel automatically.
3. If there is an alarm present, the alarm message will be displayed in the
MessageCenter and the alarm LED will flash for five seconds. If one or
more shutdown alarms are present, the alarm(s) must be cleared before
the unit will start.
4. If the unit is to be switched from Engine Operation to Electric Operation or
from Electric Operation to Engine refer to Switching Operating State.
Once the unit is operating in the desired state, observe the
MessageCenter. If the word “ACTIVE” or “MODIFIED” is displayed at the
right, the unit is equipped with IntelliSet™ settings. Refer to the
IntelliSet™ section of this book for more information.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Carrier TRANSICOLD Vector 8600MT and is the answer not in the manual?

Carrier TRANSICOLD Vector 8600MT Specifications

General IconGeneral
BrandCarrier TRANSICOLD
ModelVector 8600MT
CategoryFan
LanguageEnglish