Carrier TRANSICOLD Vector 8600MT - Adjusting Temperature Setpoints; Modifying Setpoint Values

62-11648 24
12. Changing Setpoint
Individual compartment control status and temperature display boxes are
configured left to right to match the compartments in the trailer, front to back.
The left display box shows the status of the first compartment (C1), the middle
display box shows the status of the second compartment (C2), and the right
display box shows the status of the third compartment (C3). In a two-
compartment configuration, the right display box is blank.
1. With the system powered up (START/RUN-OFF switch in the START/
RUN position) and the default screen displayed (press the BACK or EXIT
soft key if required).
2. Press the ▼or ▲ key to bring the displayed setpoint to the desired value.
Compartment 1 Compartment 2 Compartment 3
Temp 9.9
Cool Mode
Setpoint -10
Temp 28.1
Cool Mode
Setpoint 28
Temp 36.2
Cool Mode
Setpoint 36
START/STOP DIESEL
BOX
SETPOINT
STATUS OK
o
F
TEMP
-10
28.1 36.2
28
COOL COOL
36
-9.9
COOL
2
3