41 62-11648
22. Pretrip Inspection
The Pretrip Inspection should be performed before picking up any load. This
inspection is essential to ensure reliable operation of this unit. These checks
take only a few minutes.
WARNING
!
Unit may start automatically at any time even if switch is in
the OFF position. Use proper lockout/tagout procedures
before inspection/servicing. All unit inspection/servicing by
properly trained personnel only.
Before starting unit
Place unit in Inspect mode, unplug the high voltage connector and
disconnect starter solenoid connector
Drain water from bottom of fuel tank
Drain water from water separator on fuel filter (if applicable)
Check radiator coolant level
Check air cleaner indicator
Check engine oil level
Visually check condition of belt
Check door latches and hinges
Check battery cables for rubbing or chafing
Check battery terminals for cleanliness
Check channels or âTâ bar floor as well as return air bulkhead for
cleanliness and obstruction. Channels and return air bulkhead must be
free of debris for proper air circulation.
Check air chute
Exit Inspect mode and reconnect starter solenoid connector
Start unit and place in engine / continuous operation
To Next Page
Loading...
Need help?
General