Carrier ComfortVu Plus TBPL-H - Selecting System Mode; Selecting Fan Speed (for 2 and 3 Fan Speeds Configuration)

ComfortVu™ BACnet Thermostat Plus Model TBPL-H (Line voltage)Carrier Proprietary and Confidential CARRIER CORPORATION ©2020
Installation and Operation Guide All rights reserved
9
In Two setpoints configuration:
1 Press the ▲or ▼buttons once. “CL” and the setpoint
temperature for cooling will appear on display.
2 Use the ▲or ▼buttons to adjust the setpoint for cooling.
3 Press the [Mode] button or wait 3 seconds. “Ht” and the
setpoint temperature for heating will appear on display.
4 Use the ▲or ▼buttons to adjust the setpoint for heating.
Notes
:
• The setpoint for cooling must be higher than the setpoint for
heating.
• For humidity setpoint, see Technician Settings P197.
Setpoint for cooling
Setpoint for heating
Selecting system mode
Press the [Mode] button to switch between system modes.
Notes:
• During demand for cooling or heating, the active mode will
flash.
• In Auto mode, the active mode icon (Cool or Heat) will flash.
• Auto mode is not available in 2-Pipe system configuration.
Cool mode
Heat
mode
Auto
mode
Fan only
Selecting fan speed (for 2 and 3 fan speeds configuration)
Press the [Fan] button to switch between fan speeds.
Notes:
• In Auto speed, the active fan speed will appear on display.
• Medium speed available in 3 speeds configuration.
Low speed
Medium
speed
High
speed
Auto
speed