2.9 SYSTEM SETUP / CONFIGURATION WITH A REMOTE DISPLAY UNIT
With all connections completed and checked, power up the Control Unit(s) and Remote Display Unit, the
following power up screen will show for a few seconds on the Remote Display Unit.
If there is more than one Control Unit connected to the display the Modbus address needs to be set up
via the USB connection on the Control Unit before it can talk to the Remote Display Unit. Please refer to
section 2.10 for the Modbus address setup.
Figure 30 Remote Display Unit Splash Screen
After a few seconds the following will be seen on the Remote Display Unit, this shows one engine
connected but may show up to ten engines.
Figure 31 Detecting Engines
A bar graph should be displayed for each Control Unit connected to the Remote Display Unit.
Press
Note To setup Engine and Detectors and Save Logs, you must be logged in as an Engineer.
To Next Page
Loading...
