Figure 104 System Configuration Menu
Number of Engines The number of engines connected to the Remote Display Unit is
automatically detected on power up however this can be altered manually
if necessary. Use the up and down arrows to set the required value.
Detect Engines Manually requests the Remote Display Unit to check the number of
engines connected.
Set Time / Date See Figure 38 and Figure 39.
Change Engineer PIN See Figure 40 to Figure 42
Renew Software Allows the Remote Display Software to be updated if necessary.
Save Logs Allows the event logs and system test logs from all connected Control
Units to be saved on the Remote Display Unit. The saved logs may be
downloaded to a PC using the Oil Mist Manager Software.
3.11 ENGINE SCREEN ENGINEERS
Pressing the engine button below the bar graph accesses the Engine Screen
Figure 105 Engine Screen Engineers Level
Logout Returns to User level access. The system will automatically revert to User
level access after approximately 5 minutes if no buttons are press.
Menu Accesses the Engine Menu, see section 3.12
Status Accesses the Engine Status Information, see section 3.4
Test Accesses the Test Menu, see section 3.5. The function of the
Slowdown/Shutdown Relay maybe tested in Engineer Level.
Event Log Accesses the Control Unit Event Log, see section 3.6
Test Log Accesses the Control Unit Test Log, see section 5.3
Back Returns to the Engine Overview Screen
To Next Page
Loading...
