3.8 ALARM TEST
The Alarm Test allows an alarm condition to be simulated on the detector. The indications on the
detector, Control Unit and Remote Display Unit will be as per a slowdown/shutdown alarm however the
slowdown/shutdown alarm will not be activated, allowing the test to be performed without shutting
down the engine.
Press the Alarm Test button
Figure 96 Detector Alarm Test
Press the Test button
Figure 97 Detector Alarm Test Activated
The screen will revert to the engine overview screen showing the engine in alarm, it is not necessary to
press OK as shown on the above screen.
Figure 98 Engine Alarm User
To reset the alarm, press the engine button under the bar graph.
To Next Page
Loading...
