Carrier SmartView - Other Buttons; Screen Calibration; Warning Messages

4.7 - Other buttons
Button Description
Save button: Press the button to save the
modication.
Cancel button: Press the button to cancel the
modication.
Log in button: Press the button to log in at
specic access level.
Log off button: Press the button to log off.
Conrm button: Press the button to conrm
the modication.
Cancel button: Press the button to cancel the
modication.
Up button: Press the button to scroll up.
Down button: Press the button to scroll down.
Force button: Press the button to force the
parameter.
Remove Force button: Press the button to
remove the forced parameter.
Trending button: Press the button to display
trends.
Refresh button: Press the button to refresh the
view.
Zoom in button: Press the button to magnify
the current view.
Zoom out button: Press the button to expand
the current view.
Left button: Press the button to go to the left.
Rewind button: Press the button to go to the
left faster than normal.
Right button: Press the button to go to the right.
Fast-forward button: Press the button to go
the right faster than normal.
4.8 - Screen calibration
The purpose of screen calibration is to make sure that the software
acts correctly upon pressing icons on the user interface.
To calibrate the screen:
1. Press and hold anywhere on the screen.
2. The calibration process will start.
3. Please follow instructions displayed on the screen:
“Touch the target in (...) screen corner”
4.9 - Warning messages
Warning messages are used to inform the user that a problem
occurred and the requested action cannot be completed successfully.
Login failure
If the wrong password is provided, the following warning message
will be displayed:
“The password entered does not match any stored passwords”
■ Press OK and type the correct password (see section 5.8).
Saving modications
In case a parameter has been changed, but not saved with the
Save button, the following warning message will be displayed:
“Your recent changes haven't been saved (...)”
■ Press OK to continue without saving the modication.
■ Press Cancel to come back to the current screen and then
save the modication with the Save button.
4 - SMARTVIEW USER INTERFACE
12