Carrier SmartView - Software Activation Key(S)

6.23 - Software Activation Key(s)
30RB/RQ units with SmartView offer some additional options which
require Software Activation Keys:
■ Cooler uid type:
- Medium brine (option 5)
- Low brine (option 6)
■ BACnet communication (option 149)
■ Modbus communication (option 149B)
These software-protected options can be factory-installed or
installed on-site by the service technician or the customer.
Each option requires an individual software activation key.
To obtain the Software Activation Key, please contact your local
Carrier Service representative.
6.23.1 - Software options
The list of available software activation keys can be veried via
the Main menu.
To verify available software options
1. Go to the Main menu.
2. Select Software Options (OPT_STA).
The menu can be accessed when logged in at user access level.
• If the status of the option is set to “yes”, it means that the
Software Activation Key for this option is installed.
IMPORTANT: In case the controller is replaced, the Software
Activation Key must be installed again. See also section 6.23.2.
6.23.2 - Replacement mode
To enable the use of software options until the Software Activation
Key(s) is(are) installed, the Replacement mode will be activated.
■ Software options will be unlocked for a limited period of time
(7 days since the rst start of the compressor).
■ Only options that have been installed on the unit before will be
active in the Replacement mode. Option status can be veried
via the Main menu (OPT_STA – Software Options).
■ Alarm 10122 will be triggered. If the Software Activation Key is not
provided within 7 days since the rst compressor start, the alarm
will be reset automatically and software options will be blocked.
■ The Replacement mode ends when the Software Activation
Key is installed or the period of 7 days elapsed (7 days since
the rst compressor start).
6.23.3 - Software key installation
To install the Software Activation Key via SmartView
1. Go to the Main menu.
2. Navigate to the Conguration menu (logged-in users only).
3. Select Add Options (ADD_OPT).
• When installing the Software Activation Key, please make
sure that the unit is stopped.
B
C
Legend:
1. Controller MAC address
2. Software Activation Key
4. Enter the Software Activation Key.
• If the Software Key ends with two equality signs (==), then
these signs can be omitted. The Key will be accepted.
• The Software Activation Key is case-sensitive.
5. Once the Software Activation Key is provided in the Keyboard
screen, press OK.
6. Once the Software Activation Key is validated, the following
message will be displayed: “Software Activation Key Added”.
7. The parameter connected with the activated functionality is
set automatically and the control system will also be rebooted
automatically.
• If the Software Activation Key is incorrect, the following
message will be displayed: “Software Activation Key is Invalid”.
• If the Software Activation Key has been added before,
the following message will be displayed: “Key Already Set”.
6 - STANDARD CONTROL OPERATIONS AND OPTIONS
45