Carrier SmartVu - Maintenance

48
7 - WEB CONNECTION
7.1 - Web interface
The SmartVu control provides the functionality to access and control unit parameters from a web interface. To connect to the controller
via the web interface, it is necessary to know the IP address of the unit.
To verify unit IP address:
1. Go to the System menu.
2. Select Network (NETWORK).
3. Verify TCP/IP Address for “IP Network Interface J5 (eth0)”.See also section 3.3.
■ Unit default address: 169.254.1.1 (J15, eth0)
■ The unit IP address can be changed.
To access SmartVu web interface:
1. Open the web browser.
2. Enter the IP address of the unit in the address bar of the web browser. Start with https:// followed by the unit IP address.
Example: https://169.254.1.1
3. Press Enter.
4. The web interface will be loaded.
IMPORTANT: Three users can be connected simultaneously with no priority between them. The last modification is
always taken into account.
Minimum web browser configuration:
■ Internet Explorer (version 11 or higher)
■ Mozilla Firefox (version 60 or higher)
■ Google Chrome (version 65 or higher)
For security reasons the unit cannot be started / stopped via the web interface. All other operations, including monitoring unit
parameters or unit configuration, can be performed via the web browser interface.
Make sure that your network is protected from malicious
attacks and any other security threats. Do not provide open
access without proper network security safeguards.
Carrier does not hold any responsibility or liability for
damage caused by security breach.