Carrier VECTOR 1800 MT - Page 268

8-15 62-11039
11.
12.
11. Disconnect the RPM sensor.
12. Use tool (P/N : 07--60083--00) to lock the
engine flywheel
Figure 8 --15 Generator Removal
13.
15.
16.
13. Pull the harness on the top of generator out of
the way.
14. Swing out the engine.
15. Remove the fan cover (4 bolts)
16. Remove the fan blade. (1 screw)
Figure 8 --16 Generator Removal
CAUTION
The mica shim must be used during disas-
sembly of the generator from the engine.
Never attempt to remove the rotor from the
stator. Leave the shim in place until the gen-
erator is re installed on the engine.
17.
20.
19.
17. Remove 3 of the 6 flywheel bolts on
generator.
18. Insert 3 guiding rods (P/N : SKM 5671)
19.Place the mica shim between the rotor and the
stator prior to loosening any other bolts.
20. Remove the last 3 flywheel bolts.
Figure 8 --17 Generator Removal