Err 13
Cause
The initial zero range exceeds above 10% of maximum capacity.
Management
Check the loadcell state.
Over
Cause
Too heavy object is put on platform so that it may exceed the
maximum capacity.
Management
Never put the weight exceeding the maximum capacity
If the loadcell is damaged, replace the loadcell.
Errors in calibration mode
Err 22
Cause
The span weight for span calibration is set below 10% of max.
capacity.
Management
Set the span weight for span calibration more than 10% of max.
capacity in CAL 3 of calibration menu.
Err 23
Cause
The span weight for span calibration exceeds 100% of max. capacity.
Management
Set the span weight for span calibration within allowable capacity
range in CAL 3 of calibration menu.
Err 24
Cause
The resolution is set too high in comparison with loadcell output.
Management
Set the high minimum division in CAL 2.
Err 26
Cause
Zero value is too high.
Management
Check that the platform is loaded on.
28
To Next Page
Loading...
