What to do if CAS Accessories show Err 02?
If your CAS Accessories display 'Err 02', it indicates a load cell connection failure or an error in the A/D conversion. To resolve this, check the L/C connector and test the A/D conversion in Test Mode 2.
What to do if CAS Accessories show Err 01?
If your CAS Accessories display 'Err 01', it means the initial value of A/D has failed. You should check the L/C connector and test the A/D conversion in Test Mode 2 to fix this.
What to do if CAS Accessories show Err 13?
If CAS Accessories show 'Err 13', it indicates that the zero value exceeds the initial zero range. To fix this, remove some weight from the platter and then turn the power on.
What to do if CAS Accessories show Err 05?
If your CAS Accessories display 'Err 05', it means the input value is over the acceptable range. Input a value between 32 and 255 to resolve this issue.
What to do if CAS Accessories show Err 08?
If CAS Accessories show 'Err 08', the Hi limit weight is larger than the Maximum weight. Set the Hi limit weight to under the maximum weight.
What to do if CAS Accessories show Err 09?
If CAS Accessories display 'Err 09', it means the Low limit weight is larger than the Hi limit weight. To correct this, set the Low limit weight to under the Hi limit weight.
What to do if CAS Accessories show Err 22?
If CAS Accessories show 'Err 22', it means the weight for span calibration is set to under 10% of maximum capacity. The weight of Span calibration Should be set to over 10% of max. Capacity (Check it in CAL 1).
What to do if CAS Accessories show Err 23?
If CAS Accessories show 'Err 23', it means the weight for span calibration is set to over 100% of maximum capacity. The weight of Span calibration Should be set to under 100% of max. capacity (Check it in CAL 1).
What to do if CAS Accessories show Err 21?
If CAS Accessories display 'Err 21', it indicates that the resolution exceeds 1/20,000. To resolve this, lower the resolution.
What to do if CAS Accessories show Err 07?
If CAS Accessories display 'Err 07', it means the Product ID is larger than 19. The range of Product ID is 0 to 19.
Details how to connect the load cell to the indicator.
Outlines the different operational modes available within System Mode.
Provides detailed instructions and settings for the Count Mode.
Explains the settings and procedures for the Percent Mode.
Covers the operations and settings for the Accumulation Mode.
Details the steps for performing weight calibration.
Setting maximum capacity and minimum division for calibration.
Details the zero calibration steps using the PRINT key.
Details the span calibration steps.
Details on connecting the indicator to a PC via COM1.
Explanation of the CAS protocol structure and data format.
Explanation of the Limit protocol structure and data format.
Details the commands for controlling the indicator.
Lists error codes, their reasons, and solutions for troubleshooting.
General| Model | NT-200 Series |
|---|---|
| Category | Accessories |
| Display | LCD |
| Brand | CAS |
| Weighing Units | g, oz |
| Power | AC adapter |
To Next Page
