51
CAS DLP Protocol
VARIABLE DESCRIPTION
V00 Gross Weight (8 bytes)
V01 Tare Weight (8 bytes)
V02 Net Weight (8 bytes)
V03 Barcode (net weight) (8 bytes)
V04 Number of count when count mode (8 bytes)
V05 Percentage when percent mode (8 bytes)
It is impossible to print the weight, count and percentage at the same time.
If you do, only one data which is met the current mode can be printed correctly
User’s Output Message Protocol
Command (ASCII code) DESCRIPTION STATE
UM User’s Output Message Write
The Max. length of message is 40-byte. You have to input the 0xFF in the last byte.
It is printed the 20 bytes in one line and message is printed on the left-top
Explanation of abbreviation on the display
Abbreviation Description Abbreviation Description
"LOC" Key Lock "UnLoad" Empty the platform
"PASS" Input password "CALMod" Calibration mode
"A6Ain"
Input password
again
"OUEr" Over the Max. capa.
"Good" Good job "SyS" System mode
"LoAd" Put the weight "Per” Percent mode
To Next Page
Loading...
