11
MEASUREMENT PROCEDURE
Warm up the balance.
Preparation for Weighing Making a measure-ment mode
(1) Press the POWER/BRK key. The standby mark goes off
and all displays light. Check that there is no segment which is
not lit.
(2) The balance shows zero and enters the measurement mode
Measurement
(1) When using a tare, load the tare on the pan and press the
TARE key after a stability mark is lit.
(2) Check that the display shows zero.
(3) Load a sample. When the stability mark is lit, read the display.
If the total mass of the sample and tare exceeds the weighing
capacity, “
” will be displayed.
※ Tare :
A sample container or other.
Stability mark(
) : Lights when the displayed value falls within the stability band. When the
load change is slow, the displayed value will fluctuate with the stability mark
lit.
To Next Page
Loading...
Need help?
General
