10
WARM-UP
▶ Apply power in advance for one hour or more. This will allow you to immediately make an
accurate measurement.
▶ Even if the balance is not used, keep the standby mark lit (warm-up state) by pressing the
POWER/BRK key without disconnecting the AC adapter.
▶ If the balance is not used for one month or more, disconnect the AC adapter.
CAUTION NOTES
▶ put water, metal pin or any thing in the balance;
▶ open the balance case;
▶ leave anything exceeding the weighing capacity on the pan;
▶ expose the balance to anything magnetized;
▶ connect anything other than the specified equipment to the connector on the rear side of the
balance; and.
▶ give a shock to the pan.
To Next Page
Loading...
