12
MENU SELECTION
This balance is designed to permit selection of the measuring conditions to compensate for vibration
and other conditions present at the installation site. This feather permits greater weighing efficiency
and accuracy, and is referred to as “Menu Selection”.
Also in CBL series, setting the balance to “ ” (standard measurement mode) makes a
normal measurement and requires no other setting.
The menu in the CBL series consists of three classifications. Basically press the TARE
key to go to lower hierarchy, and press the POWER/BRK key to return to upper
hierarchy. Continuously pressing the POWER/BRK key returns the display to weight
display from each hierarchy with single operation.
Step
(1) Press the CAL/MENU key during the weight display.
(2) “ ”
will be displayed.
(3) Every time the CAL/MENU key is subsequently pressed, the display be changed in the order
shown below.
(4) Select the desired condition and press the TARE key. Then, it will be set or enter into the lower
hierarchy.
To Next Page
Loading...
Need help?
General
