20
REGISTRATION, CANCEL, AND CHANGE OF UNIT
Step for registration
(1) Press the CAL/MENU key and select “ ” display.
(Press the TARE key.)
(2) Press the CAL/MENU key and select “ ” display.
(Press the TARE key.)
(3) The registrable unit is displayed by every pressing the CAL/MENU key. The registerable
units are three kinds which are selected from the following 14 kinds.
g, kg, ct. pcs, %, oz, ozt, dwt, GN, Hong-kong tail, Singapore tail, Taiwan tail, Maraysia tail, and
Japanese "monme"
However, % and pcs (No. of pieces) cannot be registered simultaneously.
The stability mark is lit on the unit display currently registered.
(4) Press the TARE key on the unit display to be registered. That unit is registered.
When three kinds of unit are already registered, a new registration deletes the oldest
registration among the three registered units. However, % and pcs (No. of pieces)
cannot be registered simultaneously. Then deletes unnecessary one.
(5) Continuously pressing the POWER/BRK key returns the display to weight display.
Step for cancel
(1) Carry out the same operation described (1) to (3) above to set unit display. Selecting the same
one of the unit display which is currently registered (stability mark is lit) cancels the registration.
Step for change
(1) Pressing the UNIT key changes the unit which is already registered.
However, even if the unit of % and pcs is already registered, the display does not change to this
unit unless making a setting of reference value.
To Next Page
Loading...
