CAS CL5000J Series - Printer Hardware (Menu Code 1730); Label Size (Menu Code 1732); Sensor Calibration (Menu Code 1733); Peel Sensor (Menu Code 1734)

49
2.7.3 Printer Hardware (Menu code 1730)
( MENU → Print → Printer Hardware )
This section is to explain how to set printing H/W environments in the following table.
▶ Printer Hardware Sub-Menu
No Sub-menus Description
1 Label Size
Lable mode “Height(40)
* ( ) are default value.
2
Sensor
Calibration
You can mearsure “Gap” & “Peel” . And print out them.
Also you can test Sensor & Motor.
3 Sensor & Motor Setting Peel-off sensor.
4 Print Intensity Set the extent of intensity of label printed.
5
Adjust Feed
Length
Set adjusting values of feed length.
This value can be from “0” to “400”
6 Label Pre-print You can set preprint length.
7 Printer Initialize You can reset printer.
2.7.4 Label Size (Menu code 1732)
( MENU → Print → Printer Hardware → Label Size )
You can input “Height” of label manually. (30~80mm)
Default label size is 40mm.
If you want to use different size label roll, make sure that set up this menu.
2.7.5 Sensor Calibration (Menu code 1733)
( MENU → Print → Printer Hardware → Sensor Calibration )
This mode will automatically feed the label several times to calculate the measurement.
The average data of “Gap” & “Peel” are printed out, and displayed on screen.
It is best way to arrange label roll’s position automatically.
This menu help you to adapt all other print hadware setting, for example their intensity,
feed length, preprinting.
2.7.6 Peel Sensor (Menu code 1734)