② Place the container (Weight of container must be greater than weight data input) for TARE
OVERRIDE.
③ Pressing “TARE” key overrides current PLU tare (weight of container) and the
weightbecomes “O”.
3.4 Calling Up a PLU
There are two ways to call up a PLU by using numeric key and preset key.
3.4.1 Using Numeric Key
① Enter PLU number by using numeric keys and press “PLU” key.
EX) PLU No. 15
3.4.2 Using Speed Key
To call-up PLU number 79, and you programmed Speed key #5 to be PLU number 79,
then you need to press the following key: Speed key #5.
Note: You have to set Speed key in program mode (Menu 1160 on chapter 2.6.1)
① Press a speed key (which is save as a PLU).
EX) PLU #79=Apple, Speed key #5
To Next Page
Loading...
