53
2.8.8 Printer Sensor Test (Menu code 1865)
( MENU → Scale Config → Te st → Printer Sensor )
User may exit from this menu, using “X/ESC” key.
2.8.9 Scale Parameter (Menu code 1870)
( MENU → Scale Config → Printer Hardware → Scale Parameter )
You can set scale’s environment by changing Parameter Values.
But you must be careful how you deal it.
The Parameters are concerned with Factory Settimg.
So your missing might raise some problems.
2.8.10 Clear Memory (Menu code 1890)
( MENU → Scale Configt → Clear Memory )
2.8.10.1 Clear PLU (Menu code 1891)
( MENU → Scale Config → Clear Memory → PLU )
Clear all PLU data. This time discount data is will be cleared.
To Next Page
Loading...
Need help?
General
