50
( MENU → Print → Printer Hardware → Peel )
You can select [Y], [N] for “ACTIVE PEEL-OFF”.
Selecting [Y], printer didn’t work until you take off former printed label.
But [N], when you press print key, label was print out by compulsion.
2.7.7 Print Intensity (Menu code 1735)
( MENU → Print → Printer Hardware → Print Intensity )
You can enter any value from “0” to “4” set the tension of label.
The 2 is default value.
2.7.8 Adjust Feed Length (Menu code 1736)
( MENU → Print → Printer Hardware → Adjust Feed Length )
User may enter any value of the feed alignment from “0” to “400”.
You can adjust the printing position detail with this menu.
* 1pixel = 0.125mm , 8pixel = 1mm
2.7.9 Label Preprint (Menu code 1737)
( MENU → Print → Printer Hardware → Label Preprint )
User may select Preprint mode and any value of the preprint length from “0” to “10”.
It controls the length that label is pushed out.
2.7.10 Printer Initialize (Menu code 1738)
( MENU → Print → Printer Hardware → Printer Initialize )
Initialize printer to factory setting.
To Next Page
Loading...
