Cascade CDO-28 User Manual

15 | Page
cascadesciences.com | Tel. 503 847-9047
INSTALLATION
HARDWIRE REQUIREMENT
The oven requires permanent connect wiring (commonly known as hardwiring). Wiring to the power
source must be performed by a qualified electrical technician. All other Installation steps may be
performed by the operator.
INSTALLATION PROCEDURE CHECKLIST
Carry out the procedures and steps listed below to install the oven in a new workspace location and
prepare it for use. All procedures are found in the Installation section of this manual.
Pre-Installation
 Check that the required ambient condition for the oven are met, page 16
 Check that the spacing clearance requirements are met, page 16
• Unit dimensions may be found on page 5
 Check for performance-disrupting heat and cold sources in the environment, page 17
 Check that a suitable permanent connect electrical power supply is present, page 17
Install the oven in its workspace location
 Review the lifting and handling instructions, page 18
 Install the leveling feet, page 19
 Install the oven in its workspace location, page 19
• The oven may be connected to its power supply after this procedure.
Set up the oven for use
 Clean the oven chamber and shelving if needed, page 19
 Install the shelving, page 20

Cascade CDO-28 Specifications

General

Brand	Cascade
Model	CDO-28
Category	Laboratory Equipment
Language	English