18 | Page
cascadesciences.com | Tel. 503 847-9047
INSTALLATION
POWER FEED WIRING
The oven comes provided with an integral 6-inch (150 mm) wire braid consisting of two 10-gauge hot
wires and a 10-gauge earth ground.
The wires for power source connection should be Green/Yellow – Earth; Black – Hot; Black – Hot.
The oven must be earth grounded using the protective conductor terminal (green with yellow stripe
wire). Do not remove the protective conductor (earth connection). Removing the protective conductor will
negate the oven protections against potentially dangerous electric shocks and create a possible fire
hazard.
GENERAL POWER SAFETY
Your unit and its recommended accessories are designed and tested to meet strict safety
requirements.
For continued safe operation of your unit, always follow basic safety precautions including:
• Always hardwire the unit power feed to a protective earth-grounded electrical source that
conforms to national and local electrical codes. If the unit is not grounded, parts such as
knobs and controls may conduct electricity and cause serious injury.
• Avoid damaging the power feed. Do not bend it excessively, step on it, or place heavy
objects on it.
• A damaged power feed can be a shock or fire hazard. Never use a power feed if it is
damaged or altered in any way.
• Position the equipment so the operator can quickly and easily disconnect or uncouple the
power feed in the event of an emergency.
LIFTING AND HANDLING
The oven is heavy. Use appropriate lifting devices sufficiently rated for these loads. Follow these
guidelines when lifting the oven:
• Lift the oven only from its bottom surface.
• Doors, handles, and knobs are not adequate for lifting or stabilization.
• Restrain the oven completely while lifting or transporting so it cannot tip.
• Remove all moving parts, such as shelves and trays, and lock doors in the closed position
during transfers to prevent shifting and damage.
To Next Page
Loading...
Need help?
General