EasyManuals Logo

Cascade CDO-28 User Manual

Cascade CDO-28
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33 | Page
cascadesciences.com | Tel. 503 847-9047
OPERATION
LAUNCH A HEATING PROFILE
The oven can be run in a timed steady-state heating profile at the current temperature set point.
Allow the oven to come up to temperature prior to launching a profile. See the Setting the Timer
procedure on page 31 for how to set the length of the profile.
Note: While the Timer system is on, the oven will not heat unless a profile is running.
End of procedure
1.
Turn on the Timer System
Push to
ON ( I )
Set Timer
1 Hour, 55 Minute Profile
The Timer Display will illuminate, showing the previously programmed
profile duration.
The oven will cease heating.
2.
Launch the current profile
Press
and Hold
Set Timer
The Timer Display will start counting down.
The oven will resume heating.
Optional: Pausing a running profile
Push
The oven will cease heating until the profile is restarted, reset, or the
Timer system is turned off.
To restart the profile where it left off, press the Start/Stop “T” button
again.
3.
The oven ceases heating upon reaching “00:00”
Set Timer
Profile Complete
To resume manual heating place the Timer Switch in the OFF ( O ) position.
To launch another profile, press the “//” Reset button and enter a new
profile, or allow the previous profile to reset automatically after 5
seconds.
TIMER ACTIVATED

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cascade CDO-28 and is the answer not in the manual?

Cascade CDO-28 Specifications

General IconGeneral
BrandCascade
ModelCDO-28
CategoryLaboratory Equipment
LanguageEnglish