3 - SAFETY/DECALS
10
● DO NOT make sparks or use an open flame near the battery.
● When disconnecting battery terminals, remove the Negative (-) cable first; then remove the Positive (+). When
connecting cables, connect the Positive (+) first, then connect the Negative (-).
● Disconnect the battery (both terminals) before welding on any part of the machine. Failure to do so may cause
damage to sensitive electrical components.
● BATTERY ACID CAUSES SEVERE BURNS. Batteries contain sulfuric acid. Avoid contact with skin, eyes or
clothing. Antidote: EXTERNAL - flush with water. INTERNAL - Drink large quantities of water or milk. DO NOT
induce vomiting. Seek medical attention immediately. EYES - Flush with water for 15 minutes and seek medical
attention immediately. BATTERIES PRODUCE EXPLOSIVE GASES. Keep sparks, flame, cigars and cigarettes
away. Ventilate when charging or using in enclosed area. Always wear eye protection when working near
batteries. Wash hands after handling. KEEP OUT OF REACH OF CHILDREN.
● When working around storage batteries, remember that all of the exposed metal parts are “live”. Never lay a
metal object across the terminals because a spark, short circuit, explosion or personal injury may result.
● Battery posts, terminals and related accessories contain lead and lead compounds. Wash hands after
handling.
● Always keep safety and informational decals clean and visible. Replace decals that are damaged, lost, painted
over or can not be read.
● When assembling, operating or servicing the machine, wear protective clothing and personal safety devices
that are necessary for the particular procedure. Some personal safety devices that may be necessary are
protective shoes, face and/or eye protection, hard hat, heavy gloves, filter mask and hearing protection.
● Do Not wear jewelry or loose fitting clothing that may get caught in moving parts. Always wear close fitting
clothing. Keep hands, feet, clothing and hair away from moving parts.
● Never attempt to clear obstructions or objects from the machine while the engine is running.
● Always stop the engine and remove the key from the key switch when leaving the operator’s seat or the
machine.
● When servicing the machine, always have the machine on a firm level surface.
● If shields or guards are removed or opened for service, always replace shields or guards before operating the
machine. Never operate machine with missing or open shields or guards.
● Keep the area used for servicing the machine clean and dry. Wet or oily floors are slippery. Wet spots can be
dangerous when working with electrical equipment. Be sure all electrical outlets and tools are properly
grounded.
Battery Safety
Maintenance Safety
! !
!
!
To Next Page
Loading...
Need help?
General
