3 - SAFETY/DECALS
11
HAZARD WARNING LAMP/PARK BRAKE DISABLE SWITCH
RD05D120
HAZARD WARNING LAMP/PARK BRAKE DISABLE SWITCH - Push the upper half of the switch to the CENTER
position to activate the amber warning lamps. Push the bottom half of the switch to turn OFF the warning lamps.
Refer to Towing in this manual for park brake disable.
BEACON - IF EQUIPPED
RD05D130 RD05D120
Your Combine may be equipped with a front and rear rotating beacon. Use the rotating beacons while operating the
Combine on the road as required by local law.
HIGHWAY OPERATION
1. Comply with state and local laws governing highway safety regulations.
2. Maintain complete control of the Combine. DO NOT exceed 20 MPH (32 km/h).
3. Connect the brake pedals together with the brake latch. Make sure that the Combine brake pedal linkage is
correctly adjusted. Make certain the latch is fully engaged.
4. Keep to the right as far as possible.
5. Turn the amber warning lamps on. Make sure that the SMV symbol can be seen.
To Next Page
Loading...
Need help?
General
