11 - STORAGE
437
REMOVING FROM STORAGE
It is recommended that caution be used when
starting an engine that has been in storage.
1. Open the fuel tank shutoff valve. Open the
separator filter drain valve and remove
contaminated fuel. Close the drain valve.
2. Check that the grade of oil in the engine
crankcase is as specified in this manual.
3. Remove the plugs from the engine breather tube
and the exhaust pipe.
4. Check the coolant level in the radiator.
5. Check that the batteries are fully charged.
Connect the ground cables and tighten all
terminals. Wash your hands after handling
battery components.
6. Check brake linkages.
7. Check to make sure the feeder conveyor slip
clutch will function properly.
8. DO NOT accelerate the engine rapidly or operate
at high RPM immediately after starting.
9. Check the tension on the drive belts.
10. Inflate the tires to the correct operating
pressures.
11. Close the elevator doors and the grain tank
unloader door. Make sure the grain tank, tailings
auger trough and clean grain auger trough clean
out slots are closed.
12. Make sure that all shields are in proper position.
WARNING: Check the machine for leaks or any parts that are broken, not working correctly, or not there at
all. Before you start the machine, tighten all caps, dipsticks, battery covers, etc.
M104A
WARNING: Before starting the engine, be sure all operating controls are in neutral. This will eliminate
accidental movement of the machine or start up of power driven equipment.
M106E
WARNING: Never operate the engine in a closed building. Proper ventilation is required under all
circumstances.
M142A
!
!
!
To Next Page
Loading...
Need help?
General
