EN-21
• The countdown timer measurement operation continues even if you exit the
Timer Mode.
• Press C while a countdown operation is in progress to pause it. Press C
again to resume the countdown.
• To completely stop a countdown operation, first pause it (by pressing C), and
then press A. This returns the countdown time to its starting value.
To set the countdown start time
1. In the Timer Mode, hold down A until the hours setting
of the countdown start time starts to flash, which
indicates the setting screen.
2. Press B to move the flashing between the hours and
minutes settings.
3. While a setting is flashing, use C to increase it.
• To set the starting value of the countdown time to
24hours, set 0:00.
4. Press A to exit the setting screen.
To Next Page
Loading...
