— 8 —
5-2. Initial Setup
After first unpack of the unit, perform the following initial setup procedure before using it for the first time.
1. Load the main battery (rechargeable battery pack).
• Be sure to use the AC Adapter to charge the battery pack before doing anything else.
The unit will not be operated correctly if the backup battery is loaded before charging the battery pack.
2. Use the AC Adapter to charge the battery pack.
3. Load the backup battery.
4. Press the [Power] button.
• After a few moments the welcome screen appears.
5. Follow the steps in the Welcome Wizard.
6. When finished, the Today screen can be seen.
• Also installation of ActiveSync is necessary before communication with a desktop computer.
• If the touch panel does not respond when it is tapped or if nothing appears on the display, try
performing a full reset. If this does not restore proper operation, remove the main battery and the
backup battery and wait for about five minutes. Reload the main battery first and then the backup
battery, and perform the above procedure again from step 4.
• If the message "A problem with memory contents has been found..." appears on the display, perform
a full reset.
• While prrforming above Initial Setup or FULL RESET operations, be sure to perform the following
"Cut" and "Paste" operation. Otherwise, it can not be continued to perform these operation, and the
unit can not be completed Initial Setup or FULL RESET.
Tapping "Next" in Stylus Wizard screen, pop-up menus Wizard display will appear.
Holding down "Dr. Johnson’s office" or "Dental appointment" using the stylus, "Cut" display will appear.
Then, after holding down its "Cut" character, hold down item 11. After that, "Paste" display will appear.
Then, hold down "Paste" character using the stylus. Then, tap "Next".
To Next Page
Loading...
