Casio Cassiopeia E-200 - 9-3. Support for PocketPC 2002

— 32 —
9-3. Support for PocketPC 2002
1. IMAP4
When you are using an IMAP4 mail server, note that the mail messages on your server cannot be
deleted from the Inbox. In this case, you need to connect to your server with another computer
and delete the mail messages on the server.
2. Attachment of e-mail
A file attached to an e-mail message cannot be saved directly to a storage card. Receive the
message and file in main memory, and then copy it to a Storage card.
3. DNS value
After checking the DNS value you input for a dial up connection setup, be sure to exit by tapping
the Finish button. Do not tap the Cancel button. If you tap the Cancel button by mistake, you will
need to reconfigure the setup.
4. Application install/uninstall
Depending on the memory location where you install an application and the method that you use
to uninstall an application, you may experience problems when later trying to re-install the same
application. If this happens, use Active Sync’s Remove from both location function to uninstall
the application and then re-install it.
5. Memory area
Certain applications may not be able to recognize non-main memory storage areas (storage card
or flash memory) correctly. Error messages and failure to store data in non-main memory areas
are symptoms that indicate the application you are using falls into this category. When using such
an application, use main memory only to store data.
6. Insert/remove of CF card
Whenever you insert or remove a CF card, the system checks the status of the card, automatically
sets up the required driver, and performs other tasks. Turning off your PocketPC or removing the
card while these tasks are being performed can cause the system to lock up. If your system locks
up or freezes, try resetting your PocketPC to restore normal operation.
7. Built-in strage
•After the using dial-up connection, the error occurs when you use the built-in storage.
And when you try to write data to or read data from built-in storage, the error may occur also.
In this case, reset your Pocket PC.
•After the using dial-up connection, the error occurs when you use the built-in storage. If you
install some application software in the built-in storage, please remove all application software in
connection with a dial-up in connection from built-in storage to RAM area.