— 41 —
3. Connect the FPC and cable connector. Put LCD moldule as
shown arrow on the main PCB. Make sure end of LCD shield
plate must be fit at end of main PCB.
4. Connect the cables from backup battery and spaeker.
The pole must be right position.
5. Check the onjectives when the upper and lower case are assembled.
6. Put the side cover of right and left as shown black arrows, then pull as white arrow.
FPC between
main and
button PCB
Inverter
connector
Put cap
Cable from
backup battery
and speaker
+
-
Obstructing when
assemble
Obstructing when
assemble
Fit
To Next Page
Loading...
