OTHER SETTINGS
126
Using the Alarm
You can configure up to three alarms that cause the
camera to beep and display a specified image at the time
you specify. Specifying a movie or an audio snapshot plays
back the image and the audio at the assigned time.
Specifying a voice recording file plays the audio.
To set an alarm
1.
In the PLAY mode, press [MENU].
2.
Select the “PLAY” tab, select “Alarm”, and
then press [].
3.
Use [] and [] to select the alarm whose
setting you want to configure, and then press
[].
4.
Use [] and [] to select the setting you want
to change, and then use [] and [] to
change the selected setting.
• You can set an alarm time and configure the alarm to
sound either once or at the same time everyday. You
can also turn the alarm on or off.
5.
Press [DISP].
• You could press [SET] in place of [DISP] if you want
to configure the alarm without an image.
6.
Use [] and [] to select the scene you want
to appear at the alarm time, and then press
[SET].
7.
After all the settings are the way you want,
press [SET].
• You can configure up to three alarms, named “Alarm
1”, “Alarm 2”, and “Alarm 3”.
To Next Page
Loading...
Need help?
General
