VIEWING IMAGES ON A COMPUTER
152
1.
What you should do first depends on whether
your computer is running under Windows 98,
Me/2000 or Windows XP.
■ Windows 98/Me/2000 Users
• Start from step 2 to install the USB driver.
• Note that the example installation presented here
uses Windows 98.
■ Windows XP Users
• Installation of the USB driver is not required, so jump
directly to step 6.
2.
Set the bundled CD-ROM (CASIO Digital
Camera Software) into the CD-ROM drive of
your computer.
3.
On the menu screen that appears, click
“English”.
4.
Click [USB driver] and then [Install].
• This starts installation.
• The following steps show installation under the
English version of Windows.
IMPORTANT!
• If you want to transfer files from the camera’s built-in
memory to a computer, make sure there is no
memory card loaded in the camera before you place
it onto the USB cradle.
• If battery goes low while you are not using the AC
adaptor, data communication may stop and the
camera may shut down. Use of the special AC
adaptor is recommended to power the camera during
data communication.
• If you are using battery power without the AC
adaptor, make sure that the battery is fully charged.
Do not try to establish a connection between the camera
and computer before installing the USB driver onto the
computer. If you do, the computer will not be able to
recognize the camera.
• USB driver installation is required in the case of
Windows 98, Me, and 2000. Do not connect the
camera to a computer running one of the above
operating systems without installing the USB driver
first.
• USB driver installation is not required in the case of
Windows XP.
To Next Page
Loading...
Need help?
General
