26
Snapshot Tutorial
1. In the REC mode, press [2] ( ) to
select the flash setting you want.
Each press of [2] ( ) cycles through the
available flash settings.
• If “On” is selected for the Panel setting
(page 97), you can change the flash setting
by pressing [2] ( ) once, using [4] and
[6] to select the setting, and then pressing
[SET].
2. Press the shutter button to shoot.
Using Flash (Flash)
Auto Flash
Flash fires automatically in accordance with exposure
(amount of light and brightness) conditions.
Flash Off Flash does not fire.
Flash On
Flash always fires. This setting can be used to brighten a
subject that normally comes out dark due to daylight or
backlight (daylight synchro flash).
Red Eye
Reduction
Flash fires automatically. This type of flash can be used to
reduce the chance of redness in the subject’s eyes.
[2] ( )
Flash
2
Back lamp
Flashes orange while the flash is charging to
indicate that image recording is disabled.
• You will not be able to take another flash
snapshot until the lamp stops flashing orange,
which indicates that charging is complete.
< indicates the flash will fire.
To Next Page
Loading...
Need help?
General
