93
Other Playback Functions (PLAY)
Procedure
[p] (PLAY) * Snapshot Screen * [MENU] * PLAY Tab * Dubbing
You can add audio to a snapshot after you shoot it. You can re-record a snapshot’s
audio whenever you want. You can record up to about 30 seconds of audio for a
single snapshot.
1. Press the shutter button to start audio
recording.
2. Press the shutter button again to stop audio recording.
• Take care that you do not block the camera’s microphone
with your fingers while recording.
• Good recording results are not possible when the camera is
too far away from what you are trying to record.
• Your camera supports the following audio data formats.
– Audio Format: WAVE/IMA-ADPCM (WAV extension)
– Approximate Audio File Size:
165KB (Approximately 30 seconds of recording at 5.5KB
per second)
• Adding audio (dubbing) is not possible for the following types of images.
– Images created using MOTION PRINT
– Protected images
• To delete audio, perform the following operation:
Dubbing * Delete * [SET] * [MENU].
IMPORTANT!
• Note that you cannot restore the original audio of an Audio Snapshot after you
delete or re-record it.
Adding Audio to a Snapshot (Dubbing)
Remaining recording time
Microphone
To Next Page
Loading...
Need help?
General
