1-13
Example: To input the “FMax(” command, which determines a maximum value
A!e(CATALOG)6(CAT)
c1(EXE)
cc1(EXE)
cccccc
1(INPUT)
To close the catalog screen, press J or !J(QUIT).
Searching for a Command
This method is helpful when you know the name of the command you want to input.
1. Press !e(CATALOG) to display the catalog screen.
2. Press 6(CAT) to display the category list.
3. Move the highlighting to “1:ALL” and then press 1(EXE) or w.
This displays a list all the commands. •
4. Input some of the letters in the command name.
You can input up to eight letters.
With each letter you input, the highlighting will move to the first command name that
matches.
5. After the command you want is highlighted, press 1(INPUT) or w.
u
•
•
To Next Page
Loading...
