USB Flash Drive
EN-36
• Be sure to observe the precautions provided in the
documentation that comes with the USB flash drive.
• Avoid using a USB flash drive under the conditions
below. Such conditions can corrupt data stored on the
USB flash drive.
− Areas subjected to high temperature, high humidity,
or corrosive gas
− Areas subjected to strong electrostatic charge and
electrical noise
• Never remove the USB flash drive while data is being
written to or loaded from it. Doing so can corrupt the
data on the USB flash drive and damage the bl USB
Type A port.
• A USB flash drive can become warm after very long
use. This is normal and does not indicate malfunction.
• Static electricity conducted to the bl USB Type A port
from your hand or from a USB flash drive can cause
malfunction of the Digital Piano. If this happens, turn
the Digital Piano off and then back on again.
• Never insert anything besides a USB device that is
specified for use with this Digital Piano into the
bl USB Type A port. Doing so creates the risk of
malfunction.
• When you perform a USB flash drive operation or turn
on the Digital Piano while a USB flash drive is plugged
in, the Digital Piano initially needs to perform a
“mounting” process to prepare for data exchange with
the USB flash drive. Digital Piano operations are
momentarily disabled while a mounting process is
being performed. The LEDs above 4 SOUND MODE
and 6 a will light sequentially from left to right
during the mounting process. It may take up to 10 or 20
seconds or even longer for USB flash drive mounting
to finish. Do not attempt to perform any operation on
the Digital Piano while mounting is in progress.
Mounting needs to be performed each time a USB flash
drive is connected to the Digital Piano.
• Mounting a USB flash drive on the Digital Piano will create
a folder named MUSICDAT in the drive’s root directory if a
MUSICDAT folder does not already exist there. Use this
folder when exchanging data between the Digital Piano and
USB flash drive.
■ To connect a USB flash drive
1.
As shown in the illustration below, insert the
USB flash drive into the Digital Piano’s bl USB
Type A port.
• Carefully push the USB flash drive in as far as it will
go. Do not use undue force when inserting the USB
flash drive.
■ To disconnect a USB flash drive
1.
Check to confirm that there is no data
exchange operation being performed, and then
pull the USB flash drive straight out.
USB Flash Drive and USB Type A
Port Handling Precautions
Copyrights
You are allowed to use recordings for your own personal
use. Any reproduction of an audio or music format file,
without the permission of its copyright holder, is strictly
prohibited under copyright laws and international
treaties. Also, making such files available on the Internet
or distributing them to third parties, regardless of
whether such activities are conducted with or without
compensation, is strictly prohibited under copyright laws
and international treaties. CASIO COMPUTER CO.,
LTD. shall not be held in any way liable for any use of
this Digital Piano that is illegal under copyright laws.
Connecting a USB Flash Drive to
and Detaching It from the Digital
Piano
bl USB Type A port
USB flash drive
To Next Page
Loading...
Need help?
General
