EN-7
Overview and Setup
1.
Before turning on power, rotate the 2 volume
knob as far as it will go in the direction shown
in the illustration below.
2.
Press the 1P (Power) button to turn on
power.
Turning on power will cause the lights of the front panel
touch button to light in sequence from left to right
(3 FUNCTION to 8 GRAND PIANO). The Digital
Piano is ready to play when all touch button lights are lit.
• After pressing 1P (Power) to turn on power, do not
press any pedal until the Digital Piano is ready to play
(all touch buttons lit).
• Power may not turn on if you press the 1P (Power)
button too lightly. This does not indicate malfunction. If
this happens, apply more pressure when you press the
1P (Power) button.
3.
Use the 2 volume knob to adjust volume.
4.
To turn off power, hold down the 1P (Power)
button until all lit touch button lights turn off.
• Pressing the 1P (Power) button to turn off power actually
puts the Digital Piano into a standby state. Minute amounts
of current continue to flow within the Digital Piano in the
standby state. If you do not plan to use the Digital Piano for
a long time or if there is a lightning storm in your area, be
sure to unplug the AC adaptor from the power outlet.
• Turning off power normally causes the tone number and
other settings to return to their initial defaults. You can
enable Auto Resume (page EN-45), which will save most
settings when power is turned off.
• If Auto Resume is disabled, turning off power will initialize
settings, except for tuning (page EN-17) and touch button
luminosity (page EN-46), Battery type (page EN-46).
■ Power On Alert
After about six minutes of non-operation while the Digital
Piano is being powered by its AC adaptor, the Power On Alert
function will cause touch button lights to turn on and off
sequentially to remind you that power is on. Button lights will
return to normal (all button lights lit) if you touch a button, play
something on the keyboard, or perform some other operation.
To turn off power, hold down the 1P (Power) button until all
lit touch button lights turn off.
• You can enable or disable the Power On Alert as required.
See “Other Settings” (page EN-46).
• If you are using batteries to power the Digital Piano, power
will turn off automatically after about six minutes of non-
use. See “Auto Power Off” (page EN-7).
■ Returning to Initial Factory Defaults
You can use Factory Reset (Initialization) to return the Digital
Piano’s stored data and settings to their initial factory defaults
any time you want. For more information, see “Factory Reset
(Initialization)” (page EN-48).
This Digital Piano is designed to turn off automatically to avoid
wasting power after no operation is performed for a preset
amount of time. The Auto Power Off trigger time is about four
hours when power is being supplied by the AC adaptor, or six
minutes under battery power.
• You can disable Auto Power Off to ensure that power does
not turn off automatically during a concert, etc. To disable
Auto Power Off, perform the procedure below.
■ To enable or disable Auto Power Off
1.
While holding down 3 FUNCTION, press the
B}0 keyboard key.
• Each press of the B}0 keyboard key sounds a
notification tone and toggles Auto Power off between
enabled and disabled. For more information, see
“Notification Tones” (page EN-11).
2.
After the setting is the way you want, release
3 FUNCTION.
Turning Power On or Off
Auto Power Off
C1A0 C2 C3 C4 C5 C6 C7 C8
To Next Page
Loading...
Need help?
General
