R-88
Manager Operation
3-3-4. Busy reset
This command is used to release the busy flag of the check used by other dead terminal.
Executing this command always releases this flag, so please be careful to perform this
operation.
1. Sign on a clerk (if necessary).
2. Press <Manager> to assign manager mode.
3. Select “4. Busy Reset” and press the <YES> key.
4. Enter the appropriate check number, and then select “YES”
to execute this command.
MGR
C
01 10-10-01 12:34 000000
Manager Mode
1.System Connection Check
2.Remote On
3.Remote Off
4.Busy Reset
5.Stock Maintenance
6.Drawer for Clerk
7.CHK#(CLK Interrupt)
8.Order ID Change
↓
0.00
Busy Reset
Check No. 12
OK? YES
0.00
Busy Reset
Check No. 12
OK? YES
Normal End
0.00
To Next Page
Loading...
