R-109
QT-6600 Reference Manual
3-3-24. Clerk number
You can program clerk number directly to the <CLK#> key in the MGR mode.
1. Sign on a clerk (if necessary).
2. Press <Manager> to assign manager mode.
3. Enter “00” and the clerk number you want to set and press the
appropriate <CLK#> key.
(Entering “000000” clears the clerk number program.)
4. To terminate this step, press the <ST> key.
MGR
C
01 10-10-01 12:34 000000
Start... 0.00
MGR
C
01 10-10-01 12:34 000000
001111
C
01 097
002222
C
02 098
003333
C
03 099
004444
C
04 100
C
04 0
Hard key code
3-3-25. Operation monitor
You can monitor a clerk’s operation by monitoring display and receipt (in case of
connecting printer).
1. Sign on a clerk (if necessary).
2. Press <Manager> to assign manager mode.
3. Enter “99990000nn (nn: terminal ID No. to monitor)” and
press the <ST> to start operation monitor.
Note: Do not designate the monitored or monitoring terminal.
The display shows the screen of the monitored terminal.
The receipt shows the printout of the monitored terminal.
4. Press <ESC> twice break the monitoring.
(RS-232C printer)
normal end
error end (error code)
5. Execute this command at the terminal which is connected
with RS-232C printer(s).
(LAN printer)
normal end
error end (error code)
5. Execute this command at a terminal in the cluster.
RS-232C Printer
/1 Normal End
/2 Error End xxxx
0.00
LAN Printer
L1 Normal End
L2 Error End xxxx
0.00
To Next Page
Loading...
Need help?
General
