R-146
Registration
4-11. Eat-in / Takeout
This function is used for specifying if the customer eat in the restaurant or takeout.
When the <EAT-IN> or <TAKEOUT> key is pressed before finalization, tax exemption
will be applied.
After registering one of these keys, it is impossible to register items except void, cancel,
subtotal, finalize and partial payment (including subtotal according to the currency
conversion.) If you want to release the compulsory, press the <OPEN 2> key.
Be sure to program before using this function.
Example of receipt image
1 Hamburger •2.00
1 French fries •1.50
1 Coffee •1.00
TAKE-OUT
4-12. Scanning PLU
This function is used for registering PLU items by scanner or OBR code <OBR>.
Before using this function, you should allocate the scanning PLU file (file no. 16), connect
a scanner and allocate <OBR> key (function code = 103). Applicable OBR codes are EAN-
13, EAN-8 and UPC-A.
To register a scanning PLU item
1. Just scan the item PLU0100.
2. Enter the OBR code on the label and press the <OBR> key.
Not found PLU registration
When you scan an item which is not set in the scanning PLU file, not found error (E028)
occurs. In this case, press <NFP> key and perform a department registration. After this
procedure, this not found item is registered by department and is set to the scanning PLU
file.
<NFP> key : function code = 142
REG
C
01 10-10-01 12:34 000001
1 PLU0100 •1.00
PLU0100 •1.00
1 ST •1.00
REG
C
01 10-10-01 12:34 000001
1 PLU0100 •1.00
1 PLU0101 •2.00
PLU0101 •2.00
2 ST •3.00
To Next Page
Loading...
Need help?
General
