R-147
QT-6600 Reference Manual
1. Scan an not found item.
2. Press the <NFP> key, enter unit price and press the appropriate
department key.
Non PLU
QT-6600 accepts both PLU type and non PLU type barcode. Non PLU type barcode
includes item price/ weight. In case of registering non PLU type barcode, you should
program Non PLU table file before you use (program or register) scanning PLU items.
Refer to 4-4-5 Programming Non PLU table in the programming manual.
Non PLU table file : file no. 076
Scanning PLU maintenance
There are two ways to maintenance scanning PLU file. One is the direct maintenance and
the other is the batch maintenance. By the direct maintenance, you can add or modify
scanning PLU items directly.
By batch maintenance, you can add, modify or delete scanning PLU items to/ from the
scanning PLU file. The procedure to perform batch maintenance, program to the batch
maintenance file first, and execute batch maintenance file.
Refer to 4-4-1 Programming direct maintenance in the programming manual.
Refer to 4-4-2 Programming batch maintenance in the programming manual.
Refer to 3-3-18 Execute batch maintenance file in this manual.
Batch maintenance file : file no. 070
Price change
You can register a scanning PLU item not by the preset price in the scanning PLU file but
a new price. The method to register by a new price is as follows:
1. Enter new price and press the <PRICE CHANGE> key.
2. Perform scanning PLU registration. (This item should be programmed as an open PLU.)
<PRICE CHANGE> key : function code = 104
Mix & match
For scanning PLU, refer to 4-21 Scan Mix and match section.
REG
C
01 10-10-01 12:34 000001
1 DEPT01 •1.00
DEPT01 •1.00
2 ST •2.00
REG
C
01 10-10-01 12:34 000001
E028 Not found PLU or
C/D is mismatch.
•1.00
1 ST •1.00
To Next Page
Loading...
Need help?
General
