107
OTHER RECORDING FUNCTIONS
Resetting the Camera
Use the following procedure to reset all of the camera’s
settings to their initial defaults as shown under “Menu
Reference” on page 192.
1.
In the REC mode or the PLAY mode, press
[MENU].
2.
Select the “Set Up” tab, select “Reset”, and
then press [].
3.
Use [] and [] to select “Reset”, and then
press [SET].
• To cancel the procedure without resetting, select
“Cancel” and press [SET].
IMPORTANT!
• If you change the BESTSHOT mode sample scene
selection or if you turn off the camera while it is in the
BESTSHOT mode, the camera’s setup (except for
“REC mode” and “Zoom Position”) will be configured
according to the BESTSHOT sample scene settings
when you turn it back on again. This is true,
regardless of mode memory on/off settings.
• If you turn the camera off while in the Movie mode,
the flash will be turned off when you turn the camera
back on again, regardless of mode memory on/off
setting for the flash.
To Next Page
Loading...
Need help?
General
