117
PLAYBACK
• To exit the slideshow setting screen and cancel the
slideshow, use [] and [] to select “Cancel” and
then press [SET].
4.
Use [] and [] to select “Start”, and then
press [SET].
• This starts the slideshow.
5.
To stop the slideshow, press [SET].
• The slideshow will also stop automatically after the
amount of time you specified for “Time” elapses.
3.
Configure the slideshow settings.
• See the pages indicated below for more information.
For information about
configuring this setting:
Images
Time
Interval
Go here:
“To specify the slideshow
images” on page 118
“To specify the slideshow
time” on page 119
“To set the slideshow
interval” on page 119
IMPORTANT!
• Note that all buttons are disabled while an image
change is in progress. Wait until an image is stopped
on the monitor screen before performing a button
operation, or hold down the button until the image
stops.
• Pressing [] during a slideshow will scroll to the
previous image, while [] scrolls to the next image.
• When the slideshow comes to a movie file, it plays
the movie once and advances to the next file.
• Images copied from another digital camera or a
computer may take longer time to appear than the
slideshow interval time you specify.
• If there are indicators on the display, you can clear
them by pressing [DISP] (page 31).
To Next Page
Loading...
Need help?
General
